Installation; Securing The Rear Mounting; Installation Of The Operatoron The Rear Mounting - Aprimatic RAIDER 2500 Instrucciones Para La Instalacíon Mecánica, El Uso Y El Mantenimiento

3.

INSTALLATION

3.1

Securing the rear mounting

•
After assembly, the mounting plate can be welded onto the
pillar or secured to the masonry wall with Ø15mm steel or
cast-iron expansion bolts and M8 bolts (example in Fig.10).
CAUTION: If the masonry is not strong enough or if
the wall made from perforated bricks, you should use
chemical plugs with M8 bolts (see the chemical bolt
instructions).
3.2

Installation of the operatoron the rear mounting

•
Assemble the operator to the mounting with the screw
and washer (Fig.11 ref.A and B) and secure the parts with the
self-locking nut (Fig.11 ref.C).
!
Warning
During assembly and disassembly, handle the operator
with care. Take precautions to prevent accidents to those
handling the operator or others in the surrounding area.
OPERATOR FOR SWING GATES
RAIDER 2500
Fig.10
2 x M8 screws + 2 Ø15 mm bolts (not supplied)
Fig.11
- 19 -
note: The plate has adjuster slots to help
you position the plate precisely before
tightening the bolts.
B
C
A