Use - SOMFY HOME MOTION WireFree RTS Manual Para Instalador

Installation guide
The LED is red when the sunlight is not strong enough to trigger a
command to lower the end-product.
The LED is green when there the sunlight is strong enough to
trigger a command to lower the end-product.

6. Use

Slide the (OFF/
0DNH VXUH WKDW GHPRQVWUDWLRQ PRGH LV QRW DFWLYDWHG
0DNH VXUH WKDW VXQOLJKW VLPXODWLRQ LV QRW DFWLYDWHG
If the sunlight intensity is greater than the set sunlight threshold for
more than 5 min. (5 sec. in demonstration mode), the end-product is
lowered, stops at the level of the sensor and is then raised to slightly
above the level of the sensor.
If the sunlight intensity falls below the set sunlight threshold for more
WKDQ  PLQ  VHF LQ GHPRQVWUDWLRQ PRGH  WKHQ WKH HQGSURGXFW
is fully raised.
If the sunlight intensity rises above sunlight threshold during this
operation, then the end-product stops.
If the sunlight intensity falls below the set sunlight threshold again,
the end-product is raised fully even if the sunlight level rises
above the set value during the raise operation. The end-product
will not be lowered again during the day or will not be lowered
again until the sun has disappeared and reappeared.
10
) selector switch to
Copyright © 2010 - 2011 Somfy SAS. All rights reserved.
Sunis indoor WireFree™ RTS
.