Installation guide
Press and hold the (PROG) button on
the already assigned RTS control point
XQWLO WKH HQGSURGXFW PRYHV EDFN DQG
forth: the motor or RTS receiver RTS
enters programming mode for 2 minutes.
4) %ULHÀ\ SUHVV WKH 352* EXWWRQ RQ WKH
Sunis
Indoor
HQGSURGXFW PRYHV EDFN DQG IRUWK WKH
Sunis
Indoor
programmed.
5HSHDW RSHUDWLRQV DQG IRU HDFK RI WKH HQGSURGXFWV WR EH
assigned to this sensor.
3RVLWLRQLQJ RI WKH 6XQLV ,QGRRU :LUH)UHH 576
Clean the surface on which the sensor is to be mounted.
&KHFN WKDW WKHUH LV QRWKLQJ WKDW FDQ FDVW D VKDGRZ RQ WKH VHQVRU
5.3.1. On an inside window sill
1) Screw the suction cup to the bottom of the
sensor (A).
2) Moisten the suction cup.
Position the sensor with the sunlight intensity
detection area (B) towards the exterior and
SUHVV RQ WKH VHQVRU WR ¿[ LW LQ SODFH
WireFree™
RTS.
WireFree™
Copyright © 2010 - 2011 Somfy SAS. All rights reserved.
Sunis indoor WireFree™ RTS
The
RTS
is
A
B