Lenco SCD-6900 Manual De Usuario página 6

Important:
Since the sensitive circuitry may cause interference to a radio tuner nearby, switch this unit off while
operating other radio devices.
Due to the complexity of the MCU control, please un‐plug the main power supply of the unit if the unit
stops during operation! This is not a malfunction of the system!
Precautions for use
Installation
• Unpack all parts and remove protective material.
• Do not connect the unit to the mains before checking the main voltage and before all other
connections have been made.
• Do not cover any vents and make sure that there is a space of several centimeters around the unit for
ventilation.
Connection
1. Connect the DC plug of the included AC/DC adaptor to DC jack (22) then the AC/DC adaptor connect
to the AC outlet.
2. When you first plug the unit into the mains, the unit will go into standby mode. The Standby LED will
light up
3. Turn on the unit by pressing "On/Standby" button (17). If the LCD display (8) is on with backlighting, it
means the power supply is normal. Now the system is ready to play the music.
DC connection
For DC operation, please insert 8 pcs size C (UM‐2) batteries into the
battery compartment and remove the AC plug from AC the outlet
then disconnect the AC cord from the AC socket.
Please remove any batteries from the unit whilst using DC power
supply. It is recommended to remove any batteries from the unit if
unit will not be used for a period of time.
Setting the clock
1. Set the unit to standby mode.
2. Press and hold the "Menu/Mem/clk‐adj" button (12), the hour digit will flash on LCD display (8) Press
the Skip down
"Menu/Mem/clk‐adj" button (12) to store the hour then the minute digit will flash.
3. Press the Skip down
4. Press "Menu/Mem/Menu/clk‐adj" button (12) to store the correct hour.

The preset time will be reset completely if disconnecting the main power supply. You are
recommended to switch the system into standby mode for convenient use.

The clock will synchronize to RDS/DAB clock once receiving the RDS/DAB signal if the clock was
not set in advance.
Listening to radio
Operation
Manual tuning
1. Turn on the unit by On/Off button (17) and then press the Function button (9) until it reaches the "FM"
mode.
2. Press the Skip down
3. Adjust volume up/down button (14) for the desired volume level.
(11) or Skip up
(11) or Skip up (19) button to set the correct minutes.
(11) or Skip up (19) button to tune your desired station.
(19) button to set the correct hour. Press the
6