Electrical Connection (Uk Only) - DeLonghi ESAM4400 Manual De Instrucciones

Ocultar thumbs Ver también para ESAM4400:
Tabla de contenido

Publicidad

ELECTRICAL CONNECTION (UK ONLY)

If your appliance comes fitted with a plug, it will incorporate a
A)
13 Amp fuse. If it does not fit your socket, the plug should be cut
off from the mains lead, and an appropriate plug fitted, as
below.
WARNING: Very carefully dispose of the cut off plug after
removing the fuse: do not insert in a 13 Amp socket elsewhe-
re in the house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must
be protected by a 15 Amp fuse.
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the follo-
wing code:
Green and yellow:
Earth
Blue:
Neutral
Brown:
Live
As the colours of the wires in the mains lead may not correspond with
the coloured markings identifying the terminals in your plug, proceed as
follows:
The green and yellow wire must be connected to the terminal in the plug
marked with the letter E or the earth symbol
E
green and yellow.
L
The blue wire must be connected to the terminal marked with the letter N
N
or coloured black.
The brown wire must be connected to the terminal marked with the letter
L or coloured red.
If the plug is a moulded-on type, the fuse cover must be re-fit-
ted when changing the fuse using a 13 Amp Asta approved
fuse to BS 1362. In the event of losing the fuse cover, the plug
must NOT be used until a replacement fuse cover can be obtai-
ned from your nearest electrical dealer. The colour of the correct
replacement fuse cover is that as marked on the base of the
plug.
or coloured green or

Publicidad

Tabla de contenido
loading

Tabla de contenido