auna multimedia NR-620 Manual Del Usuario página 23

•
Fast forward:
tape winding forward direction. The " tape forward / eject " button will keeping at middle height position.
Slightly press the " Tape forward / Eject " button again to resume normal playback. The " tape forward
/ eject " button will resume to the highest position.
Remarks: Make sure the direction is correct when inserting the tape into the system. There is some search-
ing noise can be heard and the system cannot perform normal playback function during fast forward mode.
It is recommended to take out the cassette tape from the system every times after listening and don't leave
the cassette tape inside the system when not under playback mode.
Before use: Remove the stylus protector. Be sure that the tone arm is being detached from the tone arm rest
before operating and re-secured again afterwards
• Select " Phono" function from function selector (3) and set the speed selector to the proper position
depending on the record to be played.
• Place the record on the platter (use the spindle adaptor if required).
• Lift the tone arm from the rest and slowly move it to the record side. The platter will start to rotate.
• Place the tone arm to the desired position of the record.
• At the end of record, the platter will automatically stop rotating. Lift the tone arm from the record and
return it to the rest.
• To stop manually, lift the tone arm from the record and return it to the rest
Remarks: as some kind of record the auto-stop area was out of the unit setting, so it will stop before the last
rack finish. In this case, select the Auto-stop switch (30) to " Off " position, then it will run to the end of the
record but will not stop automatically (turn off the unit by power button or switch back the auto-stop switch
to " on " position to stop the platter rotate). Then put back the tone arm to the rest position.
Press the " tape forward / Eject " button half inwards during Playback mode, the
Phono
23