auna multimedia NR-620 Manual Del Usuario página 24

The system is able to encode CD, Record (from phono) and cassette deck (from tape) to MP3 format and
recording at memory media with USB connecting port or SD/MMC card.
A) CD encoding
i) Recording 1 track
• Plug in the USB pen drive for recording (make sure it and enough empty space).
• Play the CD track you want to encode/record, as normal.
• Press the " Record " button (9) during playback of the desired track
• " " & "
• After the encoding process has finished, the unit will stop playback automatically.
ii) Recording the complete CD
• Place a CD with the printed side facing up inside the CD tray & then close the CD door.
• After disc search has been completed, press the " Record " button (9) – note: please do not press "
Play/Pause/Stop " button (19) and then „record" button, otherwise, only the played track will be re-
corded.
• " " & "
• After the encoding process has finished, the unit will stop playback automatically.
iii) Recoding by program
• Place a CD with the printed side facing up inside the tray & then close the co door
• Select the desire tracks by following " CD/MP3 disc programming " procedures. Then press " Play/
Pause/Stop " button (19) to start playback.
• Press the " Record " button (9) and the unit will display flashing USB & REC symbols. Encoding is per-
forming now. After completing of encoding, unit will stop playback automatically.
Remarks:
• Insert either one type of memory media (USB pen drive or SD/MMC card) to the unit for encoding
process from CD/Phono/Tape respectively.
• The recording speed is 1:1 and according to the actual plying time of the Phono or Tape
• During copy mode, the system will copy the MP3 file only.
• The system will crate a " audio " folder for encoding file and " fcopy " for copying file.
• The recording format is preset at – MP3 bit rate : 128 kbps, sampling rate : 44.1 khz
• No song title will be recorded during encoding mode
• To interrupt the recording, press the " Record " button again during record mode.
• The system will store the file to USB source first if both USB and SD slot are being occupied during
encoding of phono or tape mode.
• Encoding CD to MP3 file or copying MP3 file from USB/SD will be successful only entire song being
encoded or copied, if terminate the encoding or copying process intermediately, there is no track be-
ing recorded nor stored to the USB or SD/MMC card.
24
Encoding: CD / Phono / Cassette -> MP3
" will be flashing on the LCD display (2) to show encoding is in progress.
" will be flashing on the LCD display (2) to show encoding is in progress.