Operating The Resolv 50A - Samson RESOLV 50a El Manual Del Propietario

Ocultar thumbs Ver también para RESOLV 50a:

Manual del usuario (52 páginas)

Contenido

página de 50

/ 50
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

RESOLV 50a Control Panel

The RESOLV 50a's rear control panel is where you will make your connections for both AC power and

audio signals. The rear panel also contains the controls to make adjustments to the overall volume and

frequency response curve. The following section details the rear panel controls and connections:

Powering the RESOLV 50a

Since the RESOLV 50a is an active studio monitor (with an on-board power amplifier and electronic crossover), it

is necesary to connect the unit to an AC power supply. Make sure that the main Power switch is set to the OFF

position and connect the supplied IEC power cable into the AC inlet.

Things that go Hum!

When running power cables, be careful not to run the AC power cords or AC extension cords in parallel

to your input cables. This will help reduce any AC hum that can be picked up. If your have to cross an

AC line with an audio line, try to cross them at a 90 degree angle for the least amount of induced hum.

Using the RESOLV 50a's balanced input connectors will greatly protect against the induced hum

thanks to the common mode rejection

(the induced hum is phase canceled)

that its balanced input circuit provides.

POWER SWITCH – The POWER

switch is used to turn on the RESOLV

50a's active electronics. When set to

the ON position, the blue, front panel

LED will illuminate indicating the unit is

powered up and ready for operation.

AC INLET - Connect the supplied

IEC power cable here.