Install The Rails - GE JX9152 Instrucciones De Instalación

1 LOCATE AND INSTALL THE BASE PAN
Set Base Pan into the front cabinet microwave oven
cutout and center it right and left. Push back until the
front flange is against the cabinet front wall. Mount
the Base Pan using 3 screws (A).
Screw A
Base Plan
Mounting Holes

2 INSTALL THE RAILS

Disconnect the microwave oven from the receptacle.
Remove everything out of the microwave oven, including
packing, Owner's Manuals, turntable and turntable support.
A protective film has been applied to some microwave
oven and trim kits. If applied, remove the film. Turn over the
microwave oven and secure the rails to oven Base Plate
by inserting 4 screws (A). Be careful not to scratch the
microwave oven.
Microwave
Rail
Oven Bottom
Flanges
Installation Instructions
Screw (A)
Door
3 INSTALL THE REAR DUCT
1. Gently return microwave oven to its upright position.
2. Remove screw A.
Screw A
3. Align the rear duct with the back of microwave oven, as
shown.
4. Slide two tabs into the slots on the right side of the back
of microwave oven.
A
5. Use two short screws to secure top of rear duct to the
back of microwave oven, as shown.
A
A. Short screws (2)
B. Rear duct
C. Back of microwave oven
3
B
A. Rear duct tabs
B. Slots
B C