Install Oven Racks - Electrolux ECFD3668AS Instrucciones De Instalación

30" & 36" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
6
Install the Oven Racks
6.1
30" Models - Ladder Rack Supports
To aid installation of the porcelain oven rack supports,
apply a thin layer of cooking oil to all the prongs of the
supports as shown in Figure 12.
Figure 12: Ladder rack supports - oil areas
1. Hold the oven rack support at a slight angle and insert
prongs into the holes at the top of the oven cavity
(Figure 13).
2. Lift the rack into the top holes, aligning the bottom
prongs with the bottom holes (Figure 13).
Figure 13: Ladder rack supports - top prongs
3. Once the upper prongs are in place, hold the oven
rack support flush with the oven side and insert the
bottom prongs into the bottom holes (Figure 14).
4. Slide the bottom prongs down into the lower holes.
Some force may be required to set the rack into place
(Figure 14).
Figure 14: Ladder rack supports - bottom prongs
6.2
30" Models - Glide Racks
The glide racks install like other oven racks.
The glide rack stop (Figure 15) must be inside the ladder
support for the rack to slide in and out properly.
Figure 15: Glide rack stop
Place the oven rack on the rack supports. Tilt the back of
the rack upward slighly to get the stop into place inside the
ladder rack. Slide the oven rack back into place
Be sure to slide the rack all the way in so that the back of
the rack stops by meeting the vertical support of the ladder
rack.
To prevent possible damage to the oven, do not attempt to
close the oven door until all oven racks are fully positioned
inside the oven cavity.
11