Electrolux ECFD3668AS Instrucciones De Instalación página 12

30" & 36" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
6.3
36" Models - Ladder Rack Supports
1. Remove the thumb screws located on each side of the
oven cavity (see Figure 16).
Figure 16: Ladder rack thumb screw
2. Place the ladder racks into the support brackets loca-
ted on the oven sides (see Figure 17).
Figure 17: Ladder rack supports
3. Replace the screws removed in Step 1.
6.4
36" Models - Glide Racks
On 36" models, the glide tracks for the gliding oven racks
come pre-installed on the ladder rack supports (see
Figure 18).
Figure 18: Ladder rack glides
The glide racks appear slightly different than the flat
racks (see Figre 19). Only the glide racks can be
installed onto the glide tracks.
1. Extend the two bottom glides fully out of the oven.
2. Place the glide rack on top of the glides.
3. Near the back of the rack, fit the rack slot onto the
track tabs. Near the front of the rack, fit the track pin
into the hole on the rack (see Figure 19).
4. Once the rack is installed, it can be pulled in and out
of the oven cavity on the glide tracks. Repeat for the
top set of glides.
Figure 19: Installing glide racks
The glide racks can only be used in these positions. The
racks may be removed from the tracks and used like a
regular flat rack on all the other rack positions.
Insert regular flat oven racks in any desired position.
12