Sauder 408920 Manual Del Usuario página 14

Step 9
NOTE: Before beginning this step, separate the NARROW EXTENSION SETS (JJ2 and KK2) from the WIDE EXTENSION
å
SETS (GG and HH). Do not confuse these SETS once they are separated.
Separate the WIDE EXTENSION SLIDES (HH) from the WIDE EXTENSION RAILS (GG) as shown in the upper diagram
å
below. Be prepared, the parts are greasy.
Fasten the WIDE EXTENSION RAILS (GG) to the ENDS (A and B) and UPRIGHTS (C3 and D3). Use eight GOLD 5/16"
å
FLAT HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that line up with the holes in the ENDS and UPRIGHTS. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
C3
1
Open end
Open end
Page 14
HH
Push the black lever in and pull the SLIDE from the RAIL.
4
3
2
GG
3
B
2
1
GG
1
2
3
GG
A
4
D3
4
4
408920
GG
Open end
1
2
GG
3
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
www.sauder.com/services
Open end
3S