Publicidad
Step 22
1
D132
Groove
Insert the DRAWER SIDES (D132 and D138) at an
å
angle into the slot at each end of the DRAWER
BOX FRONT (O).
3
Fasten the DRAWER BACK (D77) to the DRAWER SIDES (D132 and D138). Use four BLACK 1-9/16"
å
FLAT HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D707) inserts into the groove of the DRAWER BACK (D77).
å
Repeat this step for the other drawer.
å
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D138
O
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
D132
BACK groove.
VIEW THE T-LOCK BOX VIDEO
2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D707) into the grooves in
å
the DRAWER SIDES (D132 and D138) and DRAWER
BOX FRONT (O).
D77
D707
D138
408920
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D707
D132
D138
O
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(8 used in this step)
Page 27
Publicidad
