Narex VYS 20-01 Instrucciones De Uso Originales página 9

Operation
Turning on
Set the switch to the "l" position. The suction engine is activated.
Vacuuming liquids
Prior to commencing the operation, remove the filter bag and test
the functioning of the float. We recommend using a filter for wet
material collection or a filter screen.
If foam starts forming or if liquid is released from the vacuum
cleaner, immediately stop operation, turn off the appliance and
empty the waste container.
Cleaning the filter
Should the suction output drop, close the opening of the nozzle or
the suction hose with your hand. Press three times the button for
activating the filter cleaning. Such a generated air flow will clean
the filter lamellas from stuck dust.
Maintenance
• Always perform only the maintenance that is described in this
manual.
• Dispose of the vacuumed material in compliance with the Leg-
islation.
• After vacuuming liquids, remove the upper part of the vacuum
cleaner so that the filter may dry out.
Storage
Packed appliance may be stored in dry, unheated storage place
with temperature not lower than –5°C.
Unpacked appliance should be stored only in dry storage place
with temperature not lower than +5°C with exclusion of all sudden
temperature changes.
Environmental protection
Power tools, accessories and packaging should be sorted for envi-
ronmental-friendly recycling.
Only for EU countries:
Do not dispose of power tools into household waste!
According to the European Directive 2002/96/EC on waste electri-
cal and electronic equipment and its incorporation into national
law, power tools that are no longer suitable for must be separately
collected and sent for recovery in an environmental-friendly man-
ner.
Warranty
Our equipment is under warranty for at least 12 months with re-
gard to material or production faults in accordance with national
legislation. In the EU countries, the warranty period for exclusively
private use is 24 months (an invoice or delivery note is required as
proof of purchase).
Damage resulting from, in particular, normal wear and tear, over-
loading, improper handling, or caused by the user or other dam-
age caused by not following the operating instructions, or any
fault acknowledged at the time of purchase, is not covered by the
warranty.
Complaints will only be acknowledged if the equipment has not
been dismantled before being sent back to the suppliers or to an
authorised NAREX customer support workshop. Store the operat-
ing instructions, safety notes, spare parts list and proof of purchase
in a safe place. In addition, the manufacturer's current warranty
conditions apply.
Noise Information
The values were measured in compliance with EN 60 704-1.
Sound pressure level 76 dB (A).
In accuracy of measurements K = 3dB (A).
Certificate of Conformity
We declare hereby that this device meets requirements of the fol-
lowing standards and directives.
Safety:
EN 60335-1; EN 60335-2-2
Directive 2006/95/EC
Electromagnetic compatibility:
EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-3-3
Directive 2004/108/EC
2009
Narex s.r.o.
Chelčického 1932
470 01 Česká Lípa
Changes are reserved
English
Antonín Pomeisl
CEO of the company
29. 12. 2009
9