Secure The Cover And Power Up - Tesla J1772 Manual De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Rotary
Maximum
Switch
Output
Position
Current
0
Test mode
1
12A
2
16A
3
20A
4
24A
5
28A
6
32A
7
36A
8
40A
9
N/A
A
N/A
B
N/A
C
N/A
D
N/A
E
Not a valid
selection
F
Slave mode
4.
Reattach the ribbon cable to the sealing
cover.
5.
Reinstall the sealing cover. Use a T20
security pin Torx driver to lightly secure
the sealing cover by installing only the top
screw.
6.
Turn ON power.
7.
If the installation is successful, the LEDs
briefly sequentially illuminate green with a
pattern that ends with the top green LED
staying solid ON. If there is a solid or
flashing red LED, refer to Troubleshooting
on page 21 and resolve the error before
you continue.
Note: To review the pattern of blinking
lights, press and hold the RESET button
for 5 seconds.
8.
Turn OFF power.
9.
Write the contact information of the
installer on the label on the inside of the
Wall Connector.
Step-by-Step Installation Instructions
Step-by-Step Installation Instructions

Secure the Cover and Power Up

Circuit
Breaker
1.
N/A
15A
20A
2.
25A
30A
35A
40A
45A
50A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
3.
4.
5.
6.
Use a T20 security pin Torx driver to
install the remaining screws on the sealing
cover. Ensure that the cover is properly
aligned before tightening the screws to
8.8 in-lb (1.0 N-m).
Attach the outer cover to the sealing
cover starting with the latch at the top.
Engage the snaps on the sides and align
the mounting tab with the housing at the
bottom.
Use a T10 Torx driver to install the screw
that secures the bottom of the outer cover
to the housing. Tighten the screw to 4.4
in-lb (0.5 N-m).
Close any unused openings with power
and signal conduit plugs.
Note: There should not be any visible
openings to the inside of the Wall
Connector, and the Wall Connector should
be completely sealed from the
environment.
Turn ON the power. The installation is
correct if the LEDs go through a sequence
of flashing, ending with the top Green
LEDs staying solidly ON. If there is a solid
or flashing Red LED, resolve the error
before you continue (refer to
Troubleshooting on page 21).
Note: To review the pattern of blinking
lights, press and hold the Reset button for
5 seconds.
Attempt to charge the vehicle to ensure
the Wall Connector is operating correctly
and charging at the selected operating
current. For instructions on how to charge,
19

Publicidad

Tabla de contenido
loading

Tabla de contenido