Troubleshooting And Repair - CS Unitec CS 1445 Manual De Instrucciones

9
12
Acids, acetone and solvents can damage parts of the vacuum
cleaner.
Clean container and accessories with water.
Wipe the top section with a damp cloth.
Allow the container and accessories to dry.
14
Malfunctions cannot always be traced back to defects in the vacuum cleaner.
Fault
Suction power drops
Vacuum cleaner does not start
The vacuum cleaner does not start
PE emptying and disposal bag is sucked Incorrect position of rotary slide
Vacuum cleaner with dust classes M
or H
accumulating in the container
Do not try anything else, contact customer services.
15
Article designation
* depending on model
1-800-700-5919 (US/CA)
Cleaning
NOTE

Troubleshooting and repair

Cause
Filter dirty
Filter bag full
Container full
Mains plug not in socket
No mains voltage
Mains connection cable defective
Cover not properly closed
Water sensor switched off
Electrical tool not plugged into socket
on the vacuum cleaner
Solenoid valve of pneumatic on-off unit*
contaminated
Incorrect position of rotary slide
Genuine accessories
FK 4300
FKP 4300 HEPA
FKPN 3000 NANO
WWW.CSUNITEC.COM
13 Repair
the user!
customer service.
NOTE
Remedy
Clean
Change
Empty
Clean
Clean
Plug mains plug into socket
Check fuse
Replace
Close
Empty container
Plug mains plug into socket on the vacuum cleaner
Rinse with alcohol
NOTE
Properties/material
Polyester material, dust class M
info@csunitec.com
WARNING!
„3 Display and control
„7.4 Insert
(see „7.3
Order no.
416069
H 419190
M 425740
+1-203-853-9522 (Intl.)