Atlas Copco SB100 Instrucciones Para El Operario página 6

English
Maintenance
Daily:
• Check chisel holder and locking pins.
• Check that hoses and couplings are in good con-
dition.
• Check that the adapter plate bolts are sound and
have not worked loose.
• Top up the central lubrication system.
Weekly:
• Clean the hammer thoroughly
• Check the wear of the bushing. See Fig. 5 for
maximum wear limits. Excessive wear may result
in chisel breakage and damage to the piston.
• Check body and adapter plate for cracks and
wear.
• Check that the accumulator screws have not wor-
ked loose. The correct tightening torque is given
in the spare parts list.
Yearly:
• For safety reasons inspection and service should
be done at the nearest Atlas Copco service cen-
tre, or authorised workshop.
Storage
If the hammer is unused for a long time, the following
steps must be taken to protect it from rust:
• Clean the hammer thoroughly.
• Remove the chisel and lubricate the front part of
the piston, the bushing and the chisel locking me-
chanism.
• Store the hammer in an upright position. This re-
duces the risk of damage to the piston. Make
sure the hammer cannot fall over.
Accumulator
The accumulator has the safety labels shown in the
illustration.
Read through the
instruction booklet
!
carefully before
servicing or chan-
ging.
!
WARNING
If the exterior of the accumulator shows
signs of rust it should be inspected by
Atlas Copco.
6
May be charged
with NITROGEN
N
2 only!
!
WARNING
Before removing the accumulator always re-
lease the gas first!
To release the gas from the accumulator,
open the valve nut (F) by 2–3 turns (fig. 7).
Then loosen and remove the screws that se-
cure the accumulator to the hammer.
!
WARNING
THE ACCUMULATOR ON THE
SB 300/450 IS INTEGRATED INTO THE
BODY OF THE HAMMER. ALL GAS MUST
ALWAYS BE RELEASED BEFORE THE
SCREWS FOR THE LID ARE LOOSENED.
!
WARNING
Assembled accumulators are supplied char-
ged.
Accumulators supplied as spare parts are
delivered in the uncharged condition. Do
NOT charge the accumulator until it has
been securely fitted to the hammer. Incor-
rect handling incurs the risk of injury to per-
sonnel.
Fit the accumulator to the hammer using un-
damaged original screws. In the event of
corrosion or other damage to one or more
screws, all screws must be changed at the
same time.
Imperfect screws can lead to dangerous oil
leakage, or to the accumulator being blown
off the hammer. Jets of oil can seriously in-
jure the eyes and skin. Loose parts can re-
sult in serious injury to personnel.