Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions - Integrated Application
Tools You Will
Need
W A R N I N G !
While performing the
installations described in
this section; gloves, safety
glasses or goggles should
be worn.
Preparing the
Enclosure
Electrical Requirements
The appliance must be con-
nected to an individual
properly grounded electrical
outlet, protected by a 15 or
20 ampere circuit breaker
or time delay fuse.
IMPORTANT!
Door Swing
Do not include the door
within the enclosure; leave
it outside of the enclosure
to prevent the door swing
from being obstructed.
*The listed depth requirement for the installation is assuming that the electrical outlet is located in the
adjacent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.
Gloves
Safety Glasses
Drill & Hole Saw set
• It is recommended that you
do not install the wine cooler
into a corner (i.e. directly
beside a wall). This is to allow
the door to have a greater than
90° opening swing. A limited
door swing will prevent the
shelves from sliding out as
intended, and may lead to
damaging the door gasket.
• The rough cabinet opening
must be on a level floor area
and at least 26
7 /8
" (68.26cm)
deep* by 23
3 /4
" (60.33cm)
wide. The opening should also
have a height of at least 55
(140.02cm).
5
Flashlight
Measuring
Tape
• The electrical outlet may be
positioned from within either
side of the adjacent cabinetry,
or the rear of the shaded area
(as shown in Fig. B).
Important: If the electrical
outlet is surface mounted (not
flush) within the enclosure, the
depth requirement for the
installation may be affected.
• If the electrical outlet is locat-
ed inside the adjacent cabi-
netry, cut a 1
diameter hole to admit the
1 /8
"
power cord.
Fig. B
1 /8 "
55
/
140.02cm
26
7 /8 "*
/
68.26cm
Cabinets
Electrical
must be
Access: 2" /
3.81cm
3 /4 "
/ 60.33cm
23
Level
Carpenter's
Square
1 /2
" (3.81cm)
square
and
plumb.
Publicidad
Capítulos
Tabla de contenido
