Panasonic BB-HCA11CE Guia De Instalacion página 4

Mounting the Bracket and the Camera
1. Using the included template as a guide, make a
hole (φ 170 mm) in the ceiling.
2. Drive an anchor bolt (not included) into the
original ceiling and attach a nut (not included) to
the bolt.
• Drive the anchor bolt into the original ceiling
directly above the center of the hole made in
step 1.
• The end of the anchor bolt should be 38 mm
above the bottom of the ceiling board.
• The bottom of the nut should be 52 mm above
the bottom of the ceiling board.
Anchor bolt
Ceiling board
3. Secure the safety wire to the bracket using
screw C (included).
(Recommended torque 0.2~0.4 N·m
{2.039~4.079 kgf·cm})
4. Insert the bracket into the hole.
• The camera will face the direction indicated by
the arrow on the bracket.
4
Template
Nut
38 mm
52 mm
Bolt is above center of hole
Screw C
Safety wire
5. Tighten the 3 clamp screws (attached to the
bracket) and secure the bracket.
1 The clamps tighten as the screws are
tightened.
(Recommended torque 0.2~0.4 N·m
{2.039~4.079 kgf·cm})
Clockwise
2 Secure the bracket by attaching and
tightening a nut (not included) to the anchor
bolt.
6. Secure the safety wire (included with the
camera) to the camera using screw B (included
with the camera) and washer B (included with
the camera).
• Make sure you attach the safety wire when
mounting the camera to prevent the camera
from falling.
(Recommended torque 0.2~0.4 N·m
{2.039~4.079 kgf·cm})
Screw B
(Length: 10 mm,
Body diameter: 2.6 mm)
Washer B
(Inside diameter: 2.6 mm)
Screws
Clamp screw
Clamp
Ceiling board
Anchor bolt
Nut
Safety wire
Safety wire hole