System Information; Wireless Lan - Zyxel P-334WH Manual Del Usuario

Current screen information will be lost if you click Back.
STEP 1:

System Information

1 This screen is optional. You can just click Next.
• System Name is for identifying the P-334WH. You
can enter your computer's "Computer Name".
• If you leave the Domain Name blank, the domain
name obtained by DHCP from the ISP is used.
STEP 2:

Wireless LAN

Configure ONE of the following wireless security types on the P-334WH:
• Auto security: Have the P-334WH automatically generate a pre-shared key.
• None security: Have no wireless LAN security configured. If you do not enable any wireless security on your P-
334WH, your network is accessible to any wireless networking device that is within range.
• Basic security: WEP (Wired Equivalent Privacy) encrypts data frames before transmitting over the wireless net-
work. The higher the WEP Encryption, the higher the security but the slower the throughput.
• Extend (WPA-PSK or WPA2-PSK) security: Configure a Pre-Shared Key. Choose this option only if your wire-
less clients support WPA-PSK or WPA2-PSK respectively.
Note: The wireless clients and P-334WH must use the same SSID, channel ID and WPA(2)-PSK (if
WPA(2)-PSK is enabled) or WEP encryption key (if WEP is enabled) for wireless communication.
Auto or No Wireless Security
A Enter a unique name to identify the P-334WH in the wireless LAN.
B Select a wireless security level. Choose Auto or None.
C The P-334WH automatically scans for and selects a channel not in use by a nearby device. The P-334WH and
wireless client must use the same channel.
D If you select Auto and click Next, a screen pops up displaying the generated pre-shared key. Click OK to
continue. You can also view the generated pre-shared key in the Wireless LAN > General screen.
ENGLISH
7