Twin-Star International 36WM2383 Manual De Instrucciones Adjunto página 5

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 Minutes
Tools Required for Assembly (not included): Phillips head screwdriver, scissors and utility knife
ASSEMBLY INSTRUCTIONS
1. Locate the Center Front Panel (D), Center Lower
Front Panel (H), Right Front Panel (C) and Left
Front Panel (B) and set out face down on a
scratch-free surface.
Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Push the Right Front Panel and Left Front Panel
snug to the center front panel (D) and center lower
front panel (H). Make sure the Wood Dowels are
seated in the pre-drilled holes. Insert Bolts (AA) and
Washers (BB) into the holes in the mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
2. Locate Hearth/Base (A) and set out finished side up
on the floor.
Insert one Wood Dowel (CC) into each of the
pre- drilled holes.
Attach the completed Front panel assembly from
step 1 and Center Support Panel (J) to the
Hearth/Base (A). Make sure the dowels are seated
into the pre-drilled holes in the Hearth/Base. Using
Bolts (AA) and Washers (BB) attach panels through
pre-drilled holes in the mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
Fig. 1
CC
C
x 4
CC
x 4
x 8
Fig. 2
x 8
x 8
x 11
4
CC
D
B
BB BB
AA AA
H
CC
BB BB
AA AA
AA
BB
A
CC
J
CC