Alpine ICS-X7 Guía De Referencia Rápida página 15

4
When your vehicle has the Bracket, mount
the long hex bolt onto the rear panel of
the ICS-X7 and put the Rubber Cap on the
hex bolt. If your vehicle does not have the
Mounting Support, reinforce the head
unit with the metal mounting strap (not
supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*1)
already attached to the vehicle's chassis.
Connect all the leads of the ICS-X7
according to details described in the
CONNECTION section.
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
•
For the screw marked "*2, " use an appropriate screw for
the chosen mounting location.
Connection Diagram of SPST Switch (sold separately)
(If the ACC power supply is not available)
ICS-X7
•
If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold
separately).
•
The diagram and the fuse amperage shown above are in the case when ICS-X7 is used individually.
•
If the switched power (ignition) lead of the ICS-X7 is connected directly to the positive (+) post of the vehicle's battery, the
ICS-X7 draws some current (several hundred milliamperes) even when its switch is placed in the OFF position, and the
battery may be discharged.
Screw
* 2
Bolt Stud
* 1
This unit
Chassis
ACC
(Red)
BATTERY
(Yellow)
5
Slide the ICS-X7 into the dashboard until it
clicks. This ensures that the unit is properly
locked and will not accidentally come out
from the dashboard.
SPST SW (Optional)
FUSE (5A)
(Optional)
FUSE (20A)
(Optional)
Battery
13
-EN