Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CLUSTER PROGRAMMING
Setting clusters / UHF input
- The amplifier has 3 UHF inputs which are splitted over 10 clusters.
There are three possible configurations :
Input
UHF1
Number of
2
cluster(s)
2
2
To set the number of cluster(s) per input :
- Turn the button to select Split UHF mode.
- Push the button to confirm.
- Turn the button to set one configuration :
I-II
III
UHF1 cluster indicator
UHF2 cluster indicator
UHF3 cluster indicator
- Push the button to confirm.
Notes:
- UHF 1 is set for 2 clusters, UHF 2 and UHF 3 are set for different number of clusters.
- Each cluster can be switched off (Park function).
Set the non used cluster on channel 00 to switch it off (see following paragraph "Setting channels / cluster").
Tecatel
UHF2
UHF3
UHF1 clusters are indicated by the YELLOW LEDs n° 1 and 2.
8
0
UHF2 clusters are indicated by the RED LEDs n° 3, 4, 5, 6, 7, 8, 9 and 10.
7
1
UHF3 clusters are indicated by the GREEN LEDs n° 8, 9 and 10.
5
3
Split UHF
Split UHF
1
2
3
4
5
6
7
8
9
10
UHF Clusters
Split UHF
The LED is green.
The LED is red.
Display of selected configuration :
Input
Number of
cluster(s)
The LED is green.
24
Display
UHF2
UHF3
"8.0"
8
0
"7.1"
7
1
"5.3"
5
3
Publicidad
Tabla de contenido
