Tecatel CENT-TACPLUS II Manual De Usuario página 32

COPY FUNCTION
This function allows to transmit all settings from one unit to another unit or import from the memory stick (optional).
All actions have to be done on the SLAVE unit.
The MASTER unit remains in Stand-by.
- Connect master and slave unit with a DSUB9 male/male crossed cable.
- Then connect mains to the units.
- Push on the rotary button for more than 3 seconds to enter into programming mode (See page 22).
- Turn the button to select the Data Import mode.
- Push the rotary button to enter the selected mode.
3 sec.
- Push the rotary button to confirm Data Import.
Note :
If a problem occurs during data transmission the display will show an error message :
Possible causes are : wrong type of cable, no cable, bad pin contacts.
Tecatel
SLAVE
Data
The software version is displayed,
followed by a dot.
3 sec.
Data Import
The LED is green.
Data Import
The LED is now RED colored.
AL is displayed
A dot is displayed
32
MASTER