3M DBI SALA 6100562 Manual Del Usuario página 12

4.2 FALL ARREST CONNECTIONS: The Ladder Anchor is used with a Full Body Harness and a Self-Retracting Device
(SRD). Figure 10 illustrates connection of the SRD between the Harness and Ladder Anchor. Connect the SRD between
the connection eye on the Ladder Anchor and the back Dorsal D-Ring on the Harness as instructed in the instructions
included with the SRD.
5.0 INSPECTION
5.1 INSPECTION FREQUENCY: The Ladder Anchor must be inspected at the intervals defined in Section 1. Inspection
procedures are described in the "Inspection and Maintenance Log" (Table 2). Inspect all other components of the Fall
Protection System per the frequencies and procedures defined in the manufacturer's instructions.
5.2 DEFECTS: If inspection reveals an unsafe or defective condition, remove the Ladder Anchor from service immediately. Do
not attempt to repair the Fall Arrest System.
5.3 PRODUCT LIFE: The functional life of the Fall Arrest System is determined by work conditions and maintenance. As long
as the product passes inspection criteria, it may remain in service.
6.0 MAINTENANCE, SERVICING, STORAGE
6.1 CLEANING: Periodically clean the Ladder Anchor's metal components with a soft brush, warm water, and a mild soap
solution. Ensure parts are thoroughly rinsed with clean water.
6.2 SERVICE: Only 3M or parties authorized in writing by 3M may make repairs to this equipment. If the Ladder Anchor has
been subject to fall force or inspection reveals an unsafe or defective conditions, remove the system from service and
destroy.
7.0 LABELS
Figure 11 illustrates labels on the Ladder Anchor. Labels must be replaced if they are not fully legible.
12