Utilitech 6240-PHO Manual Del Usuario página 10

CARE AND MAINTENANCE
Ballast assembly replacment.
DANGER: Turn power off at the circuit breaker or fuse box before
starting balast replacement.
DANGER: DO NOT rely on wall switch alone to turn off power.
The ballast assembly can be replaced without the cutting of any wires. Use a qualified electrician.
Perform ballast replacement after removing light fixture from the wall.
Step 1: Remove protective screen (F).
Step 2: Remove bulb (D).
Step 3: Loosen the three lens assembly
screws (GG) and remove lens assembly.
Step 4: Remove the two screws (SD)
and washers (SE) connecting the
ballast (SA) to fixture housing (A) (see
Fig 7).
SB
SA
SF
SE
SD
SH
10
ON
ON
OFF
ON
ON ON
ON ON
SE
SD
SI
SF
SC
SH
Fig. 7
Lowes.com