Twin-Star International 18DM9038 Manual De Instrucciones Adjunto página 6

2. Insert Wood Dowel (CC) and screw (A-1) into the
pre-drilled holes in the completed assembly from
step 1, make sure to tighten (A-1). Push Center Top
Panel (H) snug to the completed assembly from step
1. Use a Phillips head screwdriver to tighten (A-2).
Hardware Used
Camlock
AA
(A-1,A-2)
Wood Dowel
CC
3. Insert Wood Dowel (CC) and screw (A-1) into the
pre-drilled holes of front panels, make sure to tighten
(A-1). Push Left Side Panel (E) and Right Side
Panel (F) snug to the completed assembly from
step 2. Use a Phillips head screwdriver to tighten
(A-2).
Hardware Used
Camlock
AA
(A-1,A-2)
Wood Dowel
CC
4. Locate Hearth/Base (A) and completed assembly
from step 3, lie down on scrach free surface, Insert
wood dowel (CC) into the completed assembly from
the step 3, push the Hearth/Base to the completed
assembly from the step 3 as show in diagram,
tighten Screw (DD) through the pre-drilled holes.
Hardware Used
Wood Dowel
CC
DD
Screw
Fig. 2
x 2
x 2
Fig. 3
x 8
x 8
Fig. 4
x 8
x 6
CC
5
H
CC
A-1
A-2
F
A-1
A-2
CC
A
DD
E