Low Battery; Led Indicators - PUREGEAR pureboom Manual De Usuario

Low Battery

• You'll hear a voice prompt of "Low battery, please charge"
when the battery level is less than 10%.
• The red LED will flash every 3 seconds when the battery level
is less than 10%.
Note: iOS users will see the PureBoom Wireless Earbuds
battery life indicator on your home screen when connected to
your device.

LED Indicators

• When your PureBoom Wireless Earbuds are charging – the
red LED light is on.
• When your PureBoom Wireless Earbuds have finished
charging – the red LED light will turn blue.
• When your Bluetooth is being paired – the red LED light and
blue LED light flash quickly.
• When your Bluetooth is disconnected – the red LED light
flashes quickly.
8
FCC Compliance
This device complies with Part 15 of the FCC rules and Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications or change to this equipment. Such modifications or
change could void the user's authority to operate the equipment.
This radio transmitter (identify the device by certification number or model number
if Category II) has been approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain indicated. Antenna types not
included in this list, having a gain greater than the maximum gain indicated for that
type, are strictly prohibited for use with this device.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
En
9