Operation - Ryobi RY43161 Manual Del Operador

DANGER:
Never cut near power lines, electric cords, or
other electric sources. If bar and chain jams on
any electrical cord or line, DO NOT TOUCH THE
BAR OR CHAIN! THEY CAN BECOME ELECTRI-
CALLY LIVE AND VERY DANGEROUS. Continue
to hold the pole saw by the insulated rear handle
or lay it down and away from you in a safe manner.
Disconnect the electrical service to the damaged
line or cord before attempting to free the bar and
chain from the line or cord. Contact with the bar,
chain, other conductive parts of the pole saw, or
live electric cords or lines will result in death by
electrocution, electric shock, or serious personal
injury.
WARNING:
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
head protection. Failure to do so could result in
objects being thrown into your eyes and other
possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not recom-
mended can result in serious personal injury.
NOTICE:
Before each use, inspect the entire product for
damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners
and caps and do not operate this product until all
missing or damaged parts are replaced. Please
contact customer service or a qualified service
center for assistance.

OPERATION

APPLICATIONS
You may use this product for the purposes listed
below:
 Limbing
 Pruning
ADDING BAR AND CHAIN LUBRICANT
See Figure 4
Use Bar and Chain Lubricant. It is designed for
chains and chain oilers, and is formulated to per-
form over a wide temperature range with no dilution
required.
NOTE: Pole saw comes from the factory with no bar
and chain oil added. Level should also be checked
after every 20 minutes of use and refilled as needed.
 Disconnect the pole saw from the power supply.
 Remove oil cap.
 Carefully pour the bar and chain oil into the tank.
 Wipe off excess oil.
 Check and fill the oil tank when quick view oil
indicator is below the second to last indicator line.
 Repeat as needed.
NOTE: Do not use dirty, used or otherwise con-
taminated oils. Damage may occur to the bar or
chain.
NOTE: It is normal for oil to seep from the saw when
not in use. To prevent seepage, empty the oil tank
after each use then run for one minute. When stor-
ing the unit for a long period of time (three months
or longer) be sure the chain is lightly lubricated; this
will prevent rust on the chain and bar sprocket.
QUICK VIEW
OIL INDICATOR
Page 11 — English
OIL
RESERVOIR
CAP
Fig. 4