Hold the tip of the bar up and tighten the chain
cover screw securely.
Chain is correctly tensioned when there is no slack
on the underside of the bar, the chain is snug, but
it can be turned by hand without binding.
NOTE: If chain is too tight, it will not rotate.
Loosen the chain cover screw slightly and turn
adjusting screw 1/4 turn counterclockwise. Lift the
tip of the bar up and retighten chain cover screw.
CHAIN OILER
See Figure 17.
Use Premium Bar and Chain Lubricant. It is de-
signed for chains and chain oilers and is formu-
lated to perform over a wide temperature range
with no dilution required.
Stop the motor and disconnect from power
supply.
Remove the cap and carefully pour approxi-
mately 2 oz. of bar and chain lubricant into the
bar lube reservoir.
Replace the cap and tighten securely.
Check and refill the bar lube reservoir every time
the pole saw is used.
NOTE: Do not use dirty, used, or otherwise con-
taminated lubricants. Damage may occur to the
oil pump, bar, or chain.
CHAIN MAINTENANCE
See Figure 18.
WARNING:
Before performing any maintenance, make sure
the tool is unplugged from the power supply to
avoid accidental starting and possible serious
personal injury.
For smooth and fast cutting, the chain needs to
be maintained properly. The following conditions
indicate that the chain requires sharpening:
Wood chips are small and powdery
Chain must be forced through the wood during
cutting
Chain cuts to one side
During maintenance of the chain, consider the
following:
MAINTENANCE
REMOVE
RAKER (DEPTH GAUGE)
Improper filing angle of the side plate can in-
crease the risk of a severe kickback.
Depth gauge (or raker clearance) setting de-
termines the height the cutter enters the wood
and the size of the wood chip that is removed.
Page 17 — English
CHAIN
COVER
SCREW
CAP
CLEARANCE
Fig. 16
BAR LUBE
RESERVOIR
Fig. 17
.025 in.
Fig. 18