DeWalt DXV09PA Manual De Instrucciones página 7

INSTALLING THE DISPOSABLE
FILTER BAG
1. Remove the power head of this vacuum by pulling
outward on the lid clips which is located on each
side of the vacuum, then lift the power head up.
2. Slide the cardboard collar opening rmly onto the
vacuum port de ector until it stops against the
de ector wall.
3. Position the bag so that it is distributed around
the inside of the tank.
4. Replace and secure the power head onto
the tank.
Disposable
filter bag
WET PICK-UP
The cartridge lter must be positioned over the lter
cage while vacuuming liquids. When picking up
several tanks full of liquid, the cartridge lter will
become saturated and misting may appear in the
exhaust air. At this time, you should dry or replace
the cartridge lter to eliminate the misting and
possible dripping of liquid around the lid.
WARNING:
Always shut off vacuum and disconnect the power
plug from the wall outlet before removing the
power head.
1. Place power head in an upside down position.
Remove the cartridge lter by sliding it up and
off the lter cage.
2. Shake excess dust off the cartridge lter with a
rapid up and down movement.
NOTE: WET PICK-UP ACCESSORIES SHOULD
BE WASHED PERIODICALLY, ESPECIALLY
AFTER PICKING UP WET, STICKY FLUIDS
OR SPILLS. THIS CAN BE ACCOMPLISHED
WITH A WARM SOLUTION OF SOAP
AND WATER.
3. This wet/dry vac is equipped with a oat
mechanism which will rise automatically to
cut off the air ow when the liquid in the tank
reaches a predetermined level. When this
happens, turn off vac, unplug the power cord,
and empty the dust tank.
You will know that the oat has shut the air ow off
because the suction ceases and the motor noise
becomes higher in pitch due to increased motor
speed. The liquid capacity may vary with the rate
of pickup.
IMPORTANT: To reduce the risk of damage
to the vac, do not run motor with oat in
raised position.
Float in raised
position
NOTE: IF TIPPED OVER, THE VACUUM COULD
LOSE SUCTION. IF THIS OCCURS, PLACE VAC
IN UPRIGHT POSITION AND TURN SWITCH OFF.
THIS WILL ALLOW THE FLOAT TO RETURN TO
ITS NORMAL POSITION, AND YOU WILL BE
ABLE TO CONTINUE OPERATION.
EMPTY THE TANK
WARNING:
To reduce the risk of injury from accidental
starting, unplug power cord before emptying
the dust tank.
1. Remove the power head assembly of the
wet/ dry vac by pulling outward on the lid
clips located on each side of the vac.
Lift off the power head assembly.
2. Dump the tank contents into the proper
waste disposal container.
3. Liquids may be emptied through the tank drain.
To empty, turn the unit off and remove the plug
from the wall outlet. Remove the drain cap and
deposit the liquid waste conents in a suitable
drain. After tank is empty, return the drain cap
to its original position. To continue use, plug
the cord into the wall outlet and turn the
unit on.
5
ENGLISH