Beninca ONE2 WI Manual De Usuario página 10

* After pressing the button on the first transmitter the receiver
will wait 5 secs to memorise another transmitter.
In this way all the transmitters being associated with one
channel can be recorded in sequence. After the 5 secs the
receivers exits the programming mode. When using this method
of recording in sequence it is best to temporarily remove the
antenna thereby reducing the receiver's range and limiting
disturbance.
N.B.: Once a programming mode has been entered, other
modes cannot be accessed. When programming several
Mode LED
1
1
rapid blink
Press the button P for at least 2 secs
2
2
rapid blinks
Press the button P for at least 2 secs
3
3
rapid blinks
Press the button P for at least 2 secs
4 Off
10
Function
Set pulse mode
Select switching time
Set
Bistable mode
No function
functions complete one programming sequence, indicated by
the LED going out, and restart with a new programming mode.
This function is only necessary when one of the two channels
has to be set to be timed (from 1 sec to 10 min) or with bistable
operation. The pulse operating mode is set by default (1 sec
switching). To set the times enter mode 4 (for channel 1) or
mode 5 (for channel 2) and wait until the end of the 5 rapid
blinks. The Times submenu is described in table 2.
TABLE 2
Operazioni
If the P button is not pressed within 5 secs the channel is reset to the
default pulse mode (1 sec switching).
If the P button is not pressed within 5 secs the LED will start blinking at a
rate of 1 blink/sec until the button P is pressed.
The number of blinks counted before pressing the P button selects the
switching time, as shown in table 3.
If the P button is not pressed within 5 secs the channel is set to the bist-
able mode: the relay changes status on each pulse.
Normal status.
Times Mode