Important - Beninca ONE2 WI Manual De Usuario

433,92MHz Radioreceiver 1/2 channels, multiple decoding,
compatible with ADVANTAGE system.
They are available with Molex (ONE2 WI) socket or in a plastic
box with terminal board (ONE2 WB). A special version is
available with a memory that can hold 2048 transmitters. A full
memory is indicated by 10 orange blinks.
N.B: The Advantage palm programmer and related management
software permit the use of certain advanced functions, please
consult the relevant instruction manual for more information.

IMPORTANT:

ONE2 can work with rolling code or programmable code
transmitters. The first receiver memorized will fix the
receiver decoding.
If for istance the first transmitter is a rolling code, from then
on the receiver will work with rolling code transmitters only.
Erasing the receiver memory reset decoding type also.
To optimise reception install the antenna away from metal
bodies and avoid positioning several receivers next to each
other. If no antenna is used reception will be considerably
reduced.
Memorising transmitters – Simplified procedure
To merely record one or more transmitters to activate the first
channel, follow this simplified procedure:
1 Press and release the button P on the receiver.
2 The Red LED will light up for 3 secs, then go out for 1 sec and
then light up again for 5 secs.
3 While the red LED is on, press the button on the transmitter
to associate with channel 1.
4 Other transmitters can be then be recorded by pressing a
8
ENGLISH
button within 5 secs from recording the previous transmitter.
5 To end wait 5 secs, the receiver will exit programming.
Memorising a transmitter – Remote self-learning
If a transmitter has already been memorised on the receiver the
remote radio self-learning feature can be used (without having
to use the receiver button P). Proceed as follows:
1 Press the hidden button on the memorised transmitter.
2 Press, within 5 secs., the button on the memorised
transmitter corresponding to the channel to associate with
the new transmitter.
3 Press, within 5 secs., the button on the new transmitter to
associate with the channel selected at point 2 above.
4 The receiver will memorise the new transmitter and promptly
exit programming.
Programming
Transmitters can be memorised and separate channel modes
can be set using the button "P" (see Fig.1/2). To go from one
programming mode to the next press the button P within
3 secs from one press and another. Once having selected
a programming mode, wait for about 3-4 secs and a LED
signal with indicate that programming has been entered (see
"Operations" column).
Table 1 lists the various programming modes.