Control Buttons - Fermax VEO VDS Guía Inicio Rápida

VDS
START GUIDE FOR THE VEO VDS MONITOR

CONTROL BUTTONS

LED
HOW TO PROGRAM THE VEO MONITOR
1. INSTALL
Monitor powered for the fi rst time.
The fi xed red led indicates that the monitor is powered and on (audio volume).
2. PROGRAM (Panel confi gured as MASTER)
1. With the monitor on, press the programming button. A confi rmation tone will be emitted.
2. Press the call-to-residence button. Again, a confi rmation tone is emitted.*
Note: The monitor will not work if it has not been programmed.
1
TECHNICAL CHARACTERISTICS (TFT 4,3" OSD screen)
Power supply
Standby Consumption
Audio + Video consumption
Calling consumption
Operating temperature
Code 97891 V05_16
In conversation, press to open the door.
In standby, call to guard unit (if applicable).
Additional function (see your installer).
Additional function (see your installer).
In standby, press and view the main panel´s camera. Auto-start and
select Main/Secondary camera (depending on the installation).
LED indicator of the monitor that is on.
VIDEO SETTINGS
Brightness
Contrast
Colour (only colour monitors)
programming tool
programming button

< 2 min
18 Vdc
12 mA
300 mA
400 mA
[-5º , +40ºC] / [23º, 104ºF]
AUDIO SETTINGS
Off
On
with MEDIUM volume
On
With HIGH volume
2
COMPLETE
VDS VIDEO MONITOR
MANUAL
3 3