Honeywell HG Serie Manual De Instrucciones página 15

Aire acondicionado local
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
USE AND OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
Dehumidifying Mode (DRY)
Air is dehumidified as it passes through the unit, without being in full cooling mode.
The fan speed is preset as LOW speed and can NOT be adjusted.
Note: If the unit will be used mainly as a dehumidifier, do not connect the exhaust hose.
Continuous drainage is then necessary (refer to Continuous Draining for Dehumidifier Mode).
IMPORTANT: The Dehumidifier Mode is used to support moisture reduction but should not
be expected to dehumidify to the same degree as a standard dehumidifier only appliance. The
built-in dehumidifier automatically adjusts dehumidification based on ambient room temperatures.
It is not possible to adjust to a desired humidity percentage. The front display only shows the
current and desired temperatures. It does not show humidity levels.
Fan Mode
For air circulation without air conditioner cooling.
Heating Mode*
When heating mode is selected the indicator light will shine. Heating is activated only when
the ambient temperature is below 77°F (25°C). In this mode, the desired temperature can be
set between 61°F - 88°F (16°C -31°C).
Note: The exhaust hoses must vent outside the room when using heating mode.
IMPORTANT: The Heat pump draws moisture from the air which then condenses into the internal
water tank. The unit will pause operation when the tank is full and will restart when the tank has
been emptied. It is recommended to use the Heating Mode in a room with 50% humidity or lower.
Avoid operating moisture-producing products or appliances such as a humidifier or a kettle when
using the unit in Heating Mode. See the "Draining Water Condensation in Heat Mode" section for
more information on draining the water tank.
TIMER / TEMPERATURE SET CONTROLS
The
and
buttons can be used to adjust and set your desired temperature in Cooling or
Heating* modes. They can also be used to set the Timer (see "Timer Control" below).
SLEEP MODE
Sleep Mode is for energy-saving comfort during the night. When Sleep Mode
Conditioning Cooling Mode, the fan will automatically stay on LOW Speed and the set temperature
will increase by 1°F (1°C) on the first hour. It will increase another 1°F (1°C) on the second hour, and
remain at this temperature for the rest of the night, until Sleep Mode is deactivated.
Note: The control panel lights will turn OFF after 10 seconds and light up again when any button is
pressed. When Sleep Mode is ON in Heating Mode*, the fan will automatically stay on LOW Speed
and the set temperature will decrease by 1°F (1°C) on the first hour. It will decrease another 1°F (1°C)
on the second hour, and remain at this temperature for the rest of the night, until Sleep Mode is
deactivated.
*Applicable for models with Heating feature only.
EN
8
is ON in Air

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hg09cesakg

Tabla de contenido