List Of Components - Kinderkraft LASTREE Manual De Usuario

must not be used.

List of components

1
Seat with cover and insert
2
Lower legs (a and b)
3
Tray with overlay
4
Wheels x4
Change functions and make adjustments only when the chair is unoccupied!
1. Adjustment of the product to cradle function (Fig. T):
Place the seat (1) on soft ground so that the side with upholstery and belts is at the top. Take
the lower leg (2a) and attach it to the upper front leg attached to the seat (1). Ensure the safety
device makes a characteristic click. Repeat the same procedure with the other leg (2b) (Fig. A).
Note: leg 2a has protruding plastic parts to which is attached the tray (3). To extend the legs,
press the buttons on the sides of the seat at the same time (fig. B) and extend the legs (fig. C).
The seat backrest has three adjustment positions: sitting (fig. DI) for the feeding chair and semi-
lying (fig. DII) and lying (fig. DIII) for the cradle. To adjust the product to the lying position, press
the button at the back of the seat (fig. D) and pull the backrest as far back as possible (fig. DIII).
To change from lying to semi-lying position (fig. DII), press the button at the back of the seat and
pull the backrest forward one notch. See also chapter 6 on adjusting the footrest regarding
cradle function.
Mounting of the bar:
Attach the toys (7) included with the chair in the round elements of the bar (6). Assemble both
guides. Slide the slide on the outside of the guide as shown in fig. (E) towards you while pushing
the guide down. Insert the plastic parts at the end of the toy bar (6) into the place behind the
guide (Fig. F). Make sure you hear a characteristic click.
2. Assembly of the feeding chair (Fig. U):
5
Basket
6
Bar
7
Toys to hang on the bar
8
Additional footrest
22