List Of Components - Kinderkraft LIVY Manual De Uso

Tabla de contenido

Publicidad

List of components

1.
Bouncer legs (A and B)*
2.
Bouncer base*
3.
Bouncer body*
4.
Front legs (A and B)
5.
Back legs
6.
Footrest
7.
Seating
8.
Bow with safety straps
9.
Tray
10.
Backrest
* Elements available in the set of chair and bouncer.
1. Bouncer*:
You will need a Phillips screwdriver (not supplied) to assemble the product. The second tool
you will need (if you are assembling a high bouncer) is the Allen key that is included in the set
(found under the seat of the chair).
The bouncer has two installation options: a low bouncer and a high bouncer.
1.A. Assembling the low bouncer*:
Slide the leg of the bouncer (1) into the base of the bouncer (2), the notched side of the
"adapter"‫ي‬should‫ي‬be‫ي‬on‫ي‬the‫ي‬inside‫ي‬of‫ي‬the‫ي‬structure‫(ي‬fig.‫ي‬A‫ي‬I).‫ي‬Note‫ي‬the‫ي‬notch‫ي‬at‫ي‬the‫ي‬end‫ي‬of‫ي‬the‫ي‬
base tube. It should engage with the teeth covered by the foot on the leg of the bouncer. In
the next step you will need a screwdriver. Connect the leg and the base of the bouncer with
screw 15 D (the screw should go underneath through the foot, the base and the leg of the
bouncer (fig. A II). Then repeat with the other leg. Make sure that the legs do not slide out of
the base, nor can they be twisted. Place the resultant structure on a level, flat surface. Place
11.
Silicone mat
12.
Toys (star, moon)*
13.
Bow*
14.
Seat cushion
15A
Bolts (M6x34 ) x 4
15B
Bolts (M6x22 ) x 4
15C
Bolts (M5x20 ) x 4
15D
Screw*‫(ي‬Ø4x7mm)‫ي‬x‫2ي‬
16.
Allen key
17.
Nuts (M6) x 4
34

Publicidad

Tabla de contenido
loading

Tabla de contenido