Adjusting The Headphones; Adjusting The Headband Width; Reducing The Contact Pressure; Replacing The Ear Cushions - sewerin F8 Manual De Instrucciones

4.3

Adjusting the headphones

4.3.1

Adjusting the headband width

● Pull the wire headband evenly out of the sleeves on the joint
or slide the band further into the sleeves.
Pull gently so that the headband does not pop out of the
sleeves.
4.3.2

Reducing the contact pressure

● Pull the two ear cups apart so that the headband is slightly
stretched.
Do not stretch it too far. The width of the headband can only
be reduced again a limited extent.
4.4

Replacing the ear cushions

The ear cushions can be replaced.
Note:
Change the ear cushions at room temperature where possible.
Cold temperatures can cause the edge of the cushion to tear.
1. Remove the old ear cushion.
2. If necessary replace the inner cushion.
3. Slide the new ear cushion over two adjacent corners of the
ear cup.
4. Preferably pull the cushion diagonally towards one of the op-
posite corners and slide it over the corner.
5. Finally pull the cushion over the fourth corner.
6. Check the edge of the cushion. It should lie flat on the ear cup.
18 │ English