Basic Operation; Initial System Start-Up; Turning Power On And Off; Modulator Frequency Setting - Alpine XMA-T200RF Manual De Operación

Basic Operation

)
POWER SETUP
(

Initial System Start-Up

Be sure to press the RESET switch when using the unit for
the first time, after installing the CD changer, etc., or after
changing the car battery.
1
Make sure that the power of the unit is off.
If the power is on, press the POWER button to turn off
the unit. (On the Remote Control, press and hold the
POWER button for at least 2 seconds.)
2
Press the RESET switch with a ballpoint pen, or any
other pointed object.

Turning Power On and Off

1
Press the POWER button of the Remote Display or the
Remote Control to turn on the unit.
NOTE
The unit can be turned on by pressing any button of the Remote
Display.
The volume level gradually increases to the previous
level you were listening to before the unit was turned
off. Press the POWER button on the Remote Control or
press and hold the POWER button of the Remote
Display for at least 2 seconds to turn off the unit.
NOTES
• When turning the unit On or Off with the POWER button, be
sure to lower the volume level of the factory-installed radio.
This will prevent any electrical pop noises from entering the
system.
• Once you are sure all connections are proper, you may turn
the unit on.
• When the frequencies of this unit and the specified head unit
are the same, the pop noise occurs when turning the unit on.
This is not a malfunction.
RESET
<Remote Display>
Rotary encoder
g
<Remote Control>

Modulator Frequency Setting

1
Press and hold the SETUP button of the Remote
Display or the Remote Control for at least 2 seconds.
2
Turn the rotary encoder of the Remote Display, or
press the 8 or 9 button of the Remote Control to enter
the Frequency Setting mode (displays the frequency).
3
Press the ( or ) button of the Remote Display, or
the g or f button of the Remote Control to set
the frequency.
The Frequency is varied by 200 kHz (0.2 MHz) steps
from 87.7 to 89.9 MHz.
4
Press the SETUP button of the Remote Display or the
Remote Control to return to the Normal mode.
NOTES
• Select a frequency that is not used by a strong, local FM
station. This will prevent interference while listening to CD.
• To listen to an FM broadcast, turn down the volume of the
radio then turn power off to the XMA-T200RF. Tune the radio
to your desired station and adjust the volume to your
preference.
• The initial setting at the factory is 88.7 MHz.
Tips
When you connect the unit to the optional DHA-S680, set Ai-
NET SETUP on the DHA-S680 to "CD-CHG. " For further
information about this operation, see the Owner's Manual of the
DHA-S680.

Listen to the Radio

1
To listen to your factory-installed radio, turn off the
Remote Display Unit or Remote Control by pressing
the POWER button.
NOTES
• When you set the Modulator Unit to a frequency which has no
FM broadcast, your audio system may produce some harsh,
interstation noises when CD playback is stopped.
• With the FM Modulator connected, there will be a slight loss
in signal strength to the radio.
POWER
8
f
9
SETUP
3
-EN