Fanaway EVO1 LED Manual De Instrucciones página 8

Fanaway EVO1 LED Installation Instructions
Note: To access the receiver DIP switches, remove the DIP switch cover.
Fig. 8 Remote battery compartment
OPERATING THE REMOTE:
Before you start using the remote, take the time to read through this section and
get familiar with the buttons and function of each button.
1. LED Indicator
The red LED indicator on the top of the transmitter will flash when the buttons are
active.
BUTTONS ON THE REMOTE
2. HI: Press this button to set the fan running at High speed.
3. MED: Press this button to set the fan running at Medium speed.
4. LOW: Press this button to set the fan running at Low speed.
5. OFF: Press this button to turn OFF the fan.
6. : Press this button to change the color temperature in the following order:
3000K → 5000K → 4000K → 3000K
7. : Press this button to turn ON/OFF the light and press and hold the button to access the light dimming
function.
The remote has memory function. If the fan or light is turned off by the isolating switch, it will memorise and recover
the last status when turned on next.
REVERSING SWITCH
Your ceiling fan can operate in either summer or winter mode.
SUMMER Mode: The reverse switch shall be in the "LEFT" (SUMMER) position to make the fan rotate in an
anticlockwise direction. The airflow will be directed downwards, for cooling in summer.
WINTER Mode: The reverse switch shall be in the "RIGHT" (WINTER) position to make the fan rotate in a
clockwise direction. The airflow will be directed upwards assisting in the circulation of warm air, for energy
conservation in winter.
7 | P a g e
Fig. 9 Receiver DIP switch
Fig. 10
V 1 . 0