Work - Toro 1725-TES Manual Del Operador

Before beginning to work, it is necessary to:
1. Make sure the appliance is in working order and safe to use
with the work equipment, especially the power cable and the
extension cable. If everything is not in order, the appliance must
EN
not be used.
2. Insert the plug (2) of the power supply cable (3) in the mains
supply socket (4) (Fig.2).
4. Turn the control column towards you until you find the best
position, this position should be comfortable when using the
appliance.
5. Once the ideal position has been found, release the control
column stop lever (5) to lock the handlebar.
6. Turn the safety switch towards you (6) (Fig.4).
7. Press the control levers main switch (7), located under the grips
11. Immediately afterwards, push the appliance in the same way but
in the opposite direction, so that about one quarter of the working
width overlaps the previous one.
You can work by moving the car back and forth.
12. We recommend that you vacuum up the dirt-loaded foam at
intervals with the aid of a vacuum cleaner for liquids.
.
ATTENTION: Work in slow movements to the right and left,
possibly moving back so that the operator always stands on
an area of the floor yet to be cleaned up.
ATTENTION: Keep the power supply cable behind the
operator, taking care not to operate the appliance in its vicinity
in order not to damage it.
8
1
3
6

WORK

3. Release the control handlebar from the vertical position. Press the
control column stop lever (5) in the direction indicated by the arrow
(Fig.3) and turn the control column towards yourself (Fig.4).
ATTENTION: During this operation, do not rest your foot on the
appliance.
4
2
3
on the handlebar (Fig.5).
8. The appliance will now start to move.
9. Apply a small amount of detergent solution to the floor by
pressing the lever (8) (Fig.6),
10. Push the appliance with the brush rotating from left to right or
vice versa.
6
4
ATTENTION: Do not insist too much on the same area so as
to avoid damaging the floor, also in function of the type of
brush or abrasive floor pad chosen.
ATTENTION: If you need to work in tight spaces you can turn
the control column to the vertical position.
13 13
2
5
5
7