Disposal; Troubleshooting - Toro 1725-TES Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
To dispose of the appliance, take it to a demolition centre or an
authorised collection centre.
Before scrapping the appliance, it is necessary to remove and
separate out the following materials, then send them to the
appropriate collection centres in accordance with applicable
environmental hygiene regulations:
Pad holders or brushes
Electric and electronic parts*
Plastic parts
Metallic parts
(*) In particular, contact your distributor when scrapping electric and
electronic parts.
This chapter lists the most common problems linked with the use of the appliance. If you are unable to resolve the problems with the
information given here, please contact EDIC.
PROBLEM
THE APPLIANCE DOES NOT SWITCH ON
INSUFFICIENT DETERGENT SOLUTION
ON THE PAD HOLDER
3
1
2
2

DISPOSAL

TROUBLESHOOTING

POSSIBLE CAUSE
The power cable extension is not connected
to the mains socket.
The power cable extension is not connected
to the appliance's power cable.
The electrical specifications of the appliance
should
correspond
to
the
specifications of the power supply network.
Extension cable damaged.
Overheating of the brush head motor.
The amount of detergent in the solution tank
is insufficient for the work that needs doing.
18
18
5
6
4
3
SOLUTION
Check that the plug on the extension cable
has been inserted into the mains supply
socket.
Check that the plug on the cable of the
appliance has been inserted into the socket
on the extension cable.
Make sure that the electrical specifications
of the appliance correspond to the electrical
electrical
specifications of the power supply network,
check the technical information on the serial
number plate.
Check the extension cable is not damaged,
and if it is, replace it.
Make sure that the thermal breaker on the
back of the handlebar has not tripped. If it
has, wait a few minutes until it has cooled
down, then press the specific circuit breaker
button to reactivate the power supply and
motor operation
Make sure that the amount of detergent
solution in the solution tank is sufficient for
the work to be carried out, and if necessary
fill the solution tank.
EN

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

1725-tpt

Tabla de contenido