Checking And Cleaning The Solution Draft Filter; Checking And Cleaning The Detergent Solution Spray Nozzle - Toro 1725-TES Manual Del Operador

10
EN
CHECKING AND CLEANING THE DETERGENT SOLUTION DRAUGHT FILTER
Proceed as follows to clean the detergent solution draught filter:
1. Take the device to the dedicated maintenance area.
ATTENTION: the place designated for this operation must comply with current environmental protection regulations.
2. Check that the plug (1) on the power cable (2) has been taken out of the socket (3) of the mains supply(Fig.1), and if not, disconnect it.
ATTENTION: these operations must be carried out using protective gloves to avoid any possible contact with the edges or tips of metal objects.
ATTENTION: To prevent damaging the power cable, disconnect the plug from the mains socket by directly pulling the plug and not the cable.
3. Make sure the solution tank is empty, otherwise empty it completely.
4. Remove the solution tank cap (4) (Fig.2).
5. Disconnect the detergent solution pipe (5) from the quick coupling (6) (Fig.3).
ATTENTION: users are advised to always wear protective gloves, to avoid the risk of serious injury to hands.
6. Clean the filter under running water, if necessary remove any impurities.
7. Repeat the operations in reverse order to reassemble all the parts.
1

CHECKING AND CLEANING THE DETERGENT SOLUTION SPRAY NOZZLE

To clean the detergent solution spray nozzle proceed as follows:
1. Take the device to the dedicated maintenance area.
ATTENTION: the place designated for this operation must comply with current environmental protection regulations.
2. Check that the plug (1) on the power cable (2) has been taken out of the socket (3) of the mains supply(Fig.1), and if not, disconnect it.
ATTENTION: these operations must be carried out using protective gloves to avoid any possible contact with the edges or tips of metal objects.
ATTENTION: To prevent damaging the power cable, disconnect the plug from the mains socket by directly pulling the plug and not the cable.
3. Make sure the solution tank is empty, otherwise empty it completely.
4. Remove the ring nut fixing the nozzle (4) (Fig.2).
5. Remove the spray nozzle (5), being careful not to lose the washer (6) (Fig.3).
ATTENTION: users are advised to always wear protective gloves, to avoid the risk of serious injury to hands.
6. Clean the nozzle under a jet of running water, if necessary remove any impurities.
7. Repeat the operations in reverse order to reassemble all the parts.
10
1. Insert the detergent solution pipe (7) into the hole in the solution tank (Fig.13).
2. Connect the detergent solution draught filter (7) to the quick coupling (8) (Fig.14). Make sure that the
draught filter stays inside the solution tank.
3. Insert the solution tank cap (4) (Fig.15).
7
13
3
1
2
2
5
6
11
8
7
14
5
6
4
3
17 17
9
8
12
4
15