XYZ Printing da Vinci nano Guida Rapida página 4

Printer Setup
Install the Guide Tube and Extruder Module
Insert guide tube into the
01
extruder module port.
Feed the guide tube through
04
the top cover.
Ensure that the guide tube has
07
been tightly inserted into the
feed module port.
Press the white button and
02
align the extruder module with
the bracket. Once aligned,
release the white button to
connect the extruder module
with the bracket.
Attach the top cover to the
05
machine.
Use the cramp ring to hold the
08
filament guide tube and flat
cable. (Place the cramp ring on
the flat cable marker.)
WARNING: Hazardous Moving
Parts. Keep Fingers and Other
Body Parts Away.
Connect the flat cable to the
03
extruder module. (Be sure to
insert the flat cable in the right
direction.
Direct the bottom locking
06
catches toward their slots
then press the latch to rotate
clockwise.
To load the filament, refer
Note
to the [Software Setup]
section.
4