GB
KAL II
5
Machine features
[1-1] Charging state indicator LED
[1-2] On/off switch with 3 settings
[1-3] Folding attachment handle
[1-4] Connecting socket for charging
adapter
[1-5] Magnetic foot with spherical head*
[1-6] Adapter plate*
[1-7] Specific charging adapter for coun-
try*
[1-8] Vehicle charging adapter
[1-9] Mains charging adapter*
[2-1] Threaded socket for tripod UNC 1/
4"-20
* not on all versions included in the
scope of delivery
6
Operation
Prior to initial operation: charge
battery pack for approx. 4 h!
6.1
Charging the integral battery
pack
Insert the mains or vehicle charging
adapter into the connecting socket [1-
4].
When the light is switched off, the
charging state indicator LED [1-1] dis-
plays the operating state of the internal
battery for the duration of the charging
process:
12
LED green - flashing quickly
Internal battery is charged at maximum
power.
LED green - flashing slowly
Internal battery is charged to 80%.
LED green - continuous light
Internal battery is charged to 90% and
then charged fully at reduced power.
LED red - flashing
General fault indication, e.g. incomplete
contact, short circuit, battery faulty.
LED red - continuous light
Battery temperature is outside the per-
mitted range.
LED orange
Power failure mode, see chapter 6.5.
6.2
On/Off switch [1-2]
The ON/OFF switch [1-2] has three set-
tings:
– Press once -> Switch on in lighting
mode in energy-saving stage (Stage
1: 30%)
– Press twice -> Switch to max. lumi-
nosity (Stage 2: 100%)
– Press three times -> switch off
6.3
Voltage monitoring
If the minimum operating voltage is not
reached in lighting mode with an internal
or external battery pack, the working
light goes into emergency mode with re-
duced luminosity and switches off after 2
minutes.