Makita DTD170 Manual De Instrucciones página 10

To turn on
press the
Changing the impact force
panel. Pull the switch
►
Fig.10: 1.
five steps
4. Medium 5. Soft 6. T mode 7. Button
You can change
impact force
steps: max,hard, medium, soft, and
T mode.
This allows a tightening suitable to the work.
Every time the
pressed, the number of blows
five steps.
"T"
is a
for fastening self
screws. In this mode, the tool starts to drive a
screw with faster rotation, which is suited for drilling
with the self-drillingscrew tip. Once the tool starts to
tighten the screw, it impacts in medium force grade.
For approximately one minute after releasing the
switch trigger, the impact force can be changed.
A mode,
button on the
trigger to
Changed in
2. Max 3. Hard
the
in five
button is
changes in
special mode
drilling
10 ENGLISH
start driving
mode.
►
Fig.9: 1. Button 2. Button
To release A
the button
in A
mode, press
(not the button ).