Kohler K-4108 Manual De Usuario página 11

Using the Remote Control (cont.)
Using the User Presets
When "preset 1" or "preset 2" is selected when you are seated,
front wash, rear wash, or air speed will operate at your stored
settings.
If the preset icon is pressed while the seat is occupied, the seat
will gradually (approximately 2 minutes) change to the preset
temperature.
Synchronizing the Remote Control
NOTE: Synchronize the remote control to reestablish a lost
connection. When there is no connection, the remote control screen
flashes steadily.
NOTE: Charge the remote control on the docking station before
performing these steps.
Press and hold the silver button on the top of the remote control
for 3 seconds.
The remote control will start up, and flash regularly.
Press and hold the power button on the top of the remote control.
Select the "dryer" icon until a short beep is heard.
Repeat if the remote control did not successfully synchronize with
the bidet seat.
Kohler Co. 11 1194356-5-B