Optional Accessory - DeWalt DCF809 Manual De Instrucciones

ENglIsh
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this procedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
Impact Accessories

WARNING: Use only impact accessories. Non-impact
accessories may break and cause a hazardous
condition. Inspect accessories prior to use to ensure that
they contain no cracks.
Belt Hook and Bit Clip (Fig. A, G)

Optional Accessory


WARNING: To reduce the risk of serious personal
injury, ONLY use the tool's belt hook to hang the
tool from a work belt. DO NOT use the belt hook
for tethering or securing the tool to a person or object
during use. DO NOT suspend tool overhead or suspend
objects from the belt hook.

WARNING: To reduce the risk of serious personal
injury, ensure the screw holding the belt hook is secure.
IMpoRTaNT: When attaching or replacing the belt hook
or bit clip, use only the screw
securely tighten the screw.
The belt hook 10 and bit clip
either side of the tool using only the screw
accommodate left- or right- handed users. If the belt hook
or bit clip is not desired at all, they can be removed from
the tool.
To move the belt hook or bit clip, remove the screw that
holds it in place then reassemble on the opposite side. Be
sure to securely tighten the screw.
26
WALT recommended
e
9 that is provided. Be sure to
11 can be attached to
9 provided, to
Repairs
The charger and battery pack are not serviceable.

WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by a
D WALT factory service center or a D
e
service center. Always use identical replacement parts.
spECIFICaTIoNs
DCF809
aR B2C
Made in: China China
Driver Size
No Load Speed
Max Torque
Impact per Minute
Weight
WALT authorized
e
B3 B2 BR
China China China
6.35 mm (1/4")
0-2800 /min (rpm)
192 Nm (1700 in-lbs)
0-3200 ipm
0.95 kg (2.1 lbs)