Programming Guide; Programming Parameters - Calpeda I-MAT Serie Instrucciones De Uso

8. Programming guide

ON
GB
8.1. Parameters
On the frequency
information is displayed:
Parameters of pump status

Programming parameters

Alarms
8.2. Parameter of pump status
They allow to visualize:
Working frequency of the pump
The measure of the transducer (in case of
differential mode the measure is referred to the
difference between the 2 transducers).
The current absorption.
Starting from the basic display by pushing of the
directional arrow
Example:
8.3. Programming parameters
To show the programming parameters, select
(menu).
Will be displayed progressively:
UP – User settings: these are the basis settings
that the user may change.
AP – Advanced settings: these settings are
available only to qualifi ed personnel. To enter
password is required (see section 8.5).
SA – Technical assistance settings: these are the
advanced parameters, only technical assistance
personnel are allowed to access this menu.
Password is required (see section 8.5).
PC – Constant pressure mode settings
These settings regulate the constant pressure
mode. A password is required to set these
parameters.
Page 32 / 136
converter the following
(plus) or (minus).
PP – Proportional pressure mode settings
These settings regulate the proportional pressure
mode. A password is required to set these
parameters.
tC – Constant temperature mode settings
These settings regulate the constant temperature
mode. A password is required to set these
parameters.
CF – Constant fl ow mode settings
These settings regulate the constant fl ow mode. A
password is required to set these parameters.
MAn – Fixed speed mode settings
These parameters allow activation of the fi xed
speed mode and the working frequency. Only
qualifi ed personnel are allowed to access this
menu. Password is required.
AE – Advanced parameter: this allows for the
display of secondary parameters which can be
useful for system diagnostics.
AE01 Software release
AE02 Supply voltage (V)
AE03 Last 10 alarms
AE04 Frequency converter output voltage(V)
AE05 Total working hours
AE06 Number of starts
Supply voltage visualization example
By pushing the button (menu) the UP parameter
appears. Select the AE parameter by pushing the
(plus) up to arrive at the correct parameter
AE, confi rm with (enter). Select the parameter
AE02 by pushing the button
with (enter). Supply voltage is displayed.
8.4. Programming
To enter programming, select
buttons (plus) or
programming parameter to be modifi ed and select
(enter) to confi rm. Use the pushbuttons
(plus) or (minus) to move to the parameter to
be modifi ed and select
(plus) or (minus) increase or decrease
the value. From this moment the setup icon start
blinking until the value is confi rmed with
To exit the program, push
you arrive to the basic display.
When you go in the setup mode icon will appear.
Example of parameter variation.
In order to modify the set-point pressure from 3.0
bars to 2.8 bars:
I-MAT_Ed1.indd - Operating Instructions
(plus) and confi rm
(menu). Use the
(minus) to move to the
(enter), with the buttons
(enter).
(menu) until when