Use; Before Machine Start-Up - KENT Razor E17 Instrucciones De Uso

Ocultar thumbs Ver también para Razor E17:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER
WARNING
CAUTION
CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if damaged.

BEFORE MACHINE START-UP

Brush or pad-holder installation
NOTE
Use either the brush (42) or the pad-holder (43) according to the type of floor to be cleaned.
1.
Insert the positioning pin (24) and disengage the machine transport/parking device (23b).
2.
Lift the brush/pad-holder deck (10) by prying the handlebar (2).
3.
Place the brush (42) or the pad-holder (43) under the deck.
4.
Lower the deck (10) by using the handlebar (2).
5.
Connect the power supply cable (21) to the electrical mains.
6.
Engage the brush/pad-holder by pressing the brush/pad switch (52) for a few seconds.
If the procedure is difficult, manually turn the brush/pad-holder counter-clockwise (49).
Brush/pad application guide (suggestions only)
Types of brushes available
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing
Marble
Vinyl tiles
Squeegee installation
7.
Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.
Solution tank filling
8.
Open the recovery water tank cover (41) and engage the support rod (59).
9.
Use the filler neck (35) to fill the tank (27) with a solution suitable for the work to be performed.
Do not fill the solution tank completely, leave a few centimetres from the edge.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed 104°F (40°C).
CAUTION!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
Adjustments
10.
Adjust the handlebar (2) with the knobs (3) to reach a comfortable position.
10
INSTRUCTIONS FOR USE
909 6311 000(3)2009-11
Midlite Grit 180
Midgrit 240
Razor E17
Prolite
Union Mix

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

908 7113 020

Tabla de contenido